1.開車前，應檢查各部件是否就位、牢固、料槽內是否有物料堵塞。
1.the car before, should check all parts of material jam in place, whether there is firm, tank.
2.每次飼料攪拌機組啟動后，應先空轉一定時間，詳細觀察運轉是否正常，軸承及電動機的溫升等情況，待機械運轉正常后方可進料，進料應保持均勻，輸送量應掌握適當，不得突增或超載運行。
2.every time feed mixing unit after the start, should first idling for some time, with observation of the operation is normal, bearing and motor temperature rise, to machine normal operation before feeding, feeding should be kept uniform, conveying capacity should master the proper, not sudden increase or overload operation.
3.如無特殊情況，不得負載停機。一般在停止進料后，待料槽內料全部卸完后才能停機。要經常檢查刮板鏈條和驅動裝置有無異常，一旦發現問題及時處理解決。
3.in the absence of exceptional circumstances, shall not load down. In general the stop feeding, to tank material are removed after to stop. Should always check the scraper chain and no abnormal driving device, once found problems in a timely manner to solve.
4.運轉時嚴防鐵件、大件硬物、雜物等混入輸送機內，以免損傷設備或造成其它事故。
4.Operation to prevent iron, large hard objects, and other debris mixed with the conveyor, so as not to damage the equipment or cause other accident.
5.注意保持飼料混合機組中所有軸承和驅動部分的良好潤滑，注意刮板鏈條、頭輪、支承導軌、導輪等部件不得涂抹潤滑油，以免腐蝕變質。
5. pay attention to maintain good lubrication of all bearings and drive part of the feed mixing unit, note the scraper chain, the head wheel, guide wheel, supporting guide rail and other parts shall not apply lubricating oil, so as to avoid corrosion.
飼料攪拌機：http://www.862010.cn/